CHON-001 cell line人长骨软骨永生化细胞株-BioVector NTCC质粒载体菌株细胞蛋白抗体基因保藏中心CRL-2846

价　　格：¥79850
货　　号：BioVector®-CRL-2846
产　　地：北京

竭诚为您服务！

BioVector NTCC典型培养物保藏中心: 联系人：Dr.Xu, Biovector NTCC Inc.; 电话：400-800-2947 工作QQ:1843439339 (微信同号); 邮件：Biovector@163.com; 手机：18901268599; 地址：北京; 已注册

详细信息
咨询记录(共0条)

CHON-001 cell line人长骨软骨永生化细胞株-BioVector NTCC质粒载体菌株细胞蛋白抗体基因保藏中心

CHON-001 is a fibroblast cell line that was isolated in 2001 from the cartilage of an 18-week-old, normal female donor. This cell line was deposited by ATCC and can be used in drug development research.

Product category: Human cells
Product type: hTERT-immortalized cell
Organism: Homo sapiens, human
Cell type: fibroblast
Morphology: Fibroblast-like
Tissue: Long bone; Cartilage
Disease: Normal
Applications: 3D cell culture
Drug development
High-throughput screening
Product format: Frozen
Storage conditions: Vapor phase of liquid nitrogen

Characteristics

Growth properties: Adherent
Derivation: The chondrocyte cell line, CHON-001, was derived from the long bones of an 18-week old female fetus. The primary cells were infected by the defective retrovirus containing hTERT gene under G418 selection. The defective retrovirus was collected from the supernatant of the packaging cell line, PT67 transfected with the pLXSN vector containing hTERT gene.
Age: 18 weeks gestation
Gender: Female
Immortalization method: hTERT expression
Karyotype: This is a diploid cell line of female origin. Overall, the karyology is stable with a modal chromosome number of 46 in 93% of the examined cells and a low rate of polypoidy. No consistent structural chromosomal aberrations were found in any of the cells examined.
Antigen expression: This cell line expresses the following proteins (Homo sapiens): HLA-B58, HLA-B81, HLA-Cw6, HLA-Cw8, HLA-DR7, HLA-DR12, HLA-DR52, HLA-DQ2, HLA-DQ5.
Genes expressed: positive for collagen type I and aggrecan (RT-PCR); negative for collagen type II (RT-PCR)

Handling information

Unpacking and storage instructions

Check all containers for leakage or breakage.
Remove the frozen cells from the dry ice packaging and immediately place the cells at a temperature below -130°C, preferably in liquid nitrogen vapor, until ready for use.

Complete medium

The base medium for this cell line is ATCC-formulated Dulbecco's Modified Eagle's Medium, Catalog No. 30-2002. To make the complete growth medium, add the following components to the base medium:

0.1mg/ml G-418
10% heat-inactivated fetal bovine serum

Temperature

37°C

Atmosphere

95% Air, 5% CO2

Handling procedure

To ensure the highest level of viability, thaw the vial and initiate the culture as soon as possible upon receipt. If storage of the frozen culture is necessary upon arrival, store the vial in liquid nitrogen vapor phase and NOT at –70°C. Storage at –70°C will result in loss of viability.

Prepare a 25 cm2 or a 75 cm2 culture flask containing the recommended complete culture medium. Prior to the addition of the vial contents, the vessel containing the growth medium should be placed in the incubator for at least 15 minutes to allow the medium to reach its normal pH (7.0 to 7.6) and to avoid excessive alkalinity of the medium during recovery of the cells.
Thaw the vial by gentle agitation in a 37°C water bath. To reduce the possibility of contamination, keep the O-ring and cap out of the water. Thawing should be rapid (approximately 2 minutes).
Remove the vial from the water bath as soon as the contents are thawed, and decontaminate by dipping in or spraying with 70% ethanol. All operations from this point on should be carried out under strict aseptic conditions.
Transfer the vial contents to a centrifuge tube containing 9.0 mL of complete culture medium and centrifuge the cell suspension at approximately 125 x g for 5 to 7 minutes.
Discard the supernatant and resuspend the cells in fresh growth medium (see the batch-specific information for the recommended dilution ratio). Add this suspension to the prepared culture vessel.
Incubate the culture at 37°C in a suitable incubator.
A 5% CO2/95% air atmosphere is recommended if using the medium described on this product sheet.

Subculturing procedure

Volumes are given for T-75 flasks; proportionally reduce or increase the amount of dissociation medium for culture vessels of other sizes.

Remove and discard culture medium.
Add 2.0-3.0 mL of 0.05% Trypsin-0.53mM EDTA solution to the flask and observe cells under an inverted microscope until the cell layer is dispersed (usually within 5 to 10 minutes).
Note: To avoid clumping do not agitate the cells by hitting or shaking the flask while waiting for the cells to detach. Cells that are difficult to to detatch may be placed at 37°C to facilitate dispersal.
Add 6.0 to 8.0 mL of complete growth medium and aspirate cells by gently pipetting.
Transfer cell suspension to a centrifuge tube and spin at approximately 125 x g for 5 to 15 minutes.
Discard supernatant and resuspend cells in fresh growth medium.
Add appropriate aliquots of cell suspension to new culture vessels. An inoculum of 2 X 103 to 3 X 103 viable cells/cm2 is recommended. Subculture when cell concentration reaches between 1 x 104 and 2 x 104 cells/cm2.
Incubate cultures at 37°C.

Subcultivation Ratio: A subcultivation ratio of 1:4 to 1:6 is recommended

Reagents for cryopreservation

Heat-inactivated FBS supplemented with 10% (v/v) DMSO (ATCC 4-X)

Quality control specifications

Mycoplasma contamination: Not detected
Population doubling capacity: ≥ 15 in complete growth medium
STR profiling: Amelogenin: X
CSF1PO: 10,11
D13S317: 12,14
D16S539: 11,13
D5S818: 11,12
D7S820: 12
TH01: 6,7
TPOX: 8,11
vWA: 16,17
D3S1358: 14,16
D21S11: 30.2,36
D18S51: 12,15
Penta_E: 8,10
Penta_D: 8,12
D8S1179: 12,14
FGA: 20,25
D19S433: 10,13
D2S1338: 19,25